Towa APN-100 Applicator Specifications:
| Model |
Label
GAP |
Label Size STROKE |
Label Size WIDTH |
Max Outer Diameter |
Towa AP65-100
(now APN-100) |
2-3 mm |
18-60 mm |
55-100 mm |
100 mm |
Notice: The width of release liner can be applicable +2mm at both sides.
Determining Your Towa APN Applicator Needs:
The following specifications offer guidelines to use when selecting the appropriate dispenser for your needs.
| Dimension: |
100mm |
|
|
| Roll Size: |
88.9mm OD
|
|
|
| Core Size: |
25.4mm ID
|
|
|
| Max Label Width: |
98.425mm
|
|
|
| Min Label Width: |
55mm
|
|
|
| Max Label Repeat: |
63.5mm
|
|
|
| Min Label Repeat: |
6.35mm
|
|
|
| Die Cut Only: |
YES |
|
|
Notes: OD refers to "Outer Dimension" of the roll, while ID refers to "Inner Dimension" of the core. "Label Repeat" indicates the distance from the beginning of one label to the beginning of the next label.
General:
Label applicators increase productivity and help the bottom line. Every business that uses labels can benefit from this label applicator.
Towa applicators use an exclusive label edge detector called "Mech-Sensor system" which automatically detects the leading edge of the label providing complete accuracy in dispensing. Each of three applicators can dispense any type of label and requires no special liner tool, cartridges or cassettes. There are three types of APN applicators depending on width of the labels. APN-30 is easy to handle, APN-60 is the most popular and APN-100 is convenient for wide labels.
Key Points:
- No feeding holes, slits or eye-marks (black marks) required on release liner
- No mechanical adjustment is needed in different sizes of labels
- Different size of labels within the specifications can be dispensed and applied by the specific applicator
- 2-3mm gap between each label is required
- Max. 100mm width label can be dispensed and applied (APN-100). There is no similar tool around.
- The Mech-Sensor detects a height of label from 18mm up to 60mm without any adjustment.
- You can use labels in roll, printed barcode labels and rewound rolls.
Media Specifications:
- It's unnecessary to make a slit or slot on backing paper for feeding of labels.
- Labels with less than 50ųm thickness is unacceptable for all models.
- Some types of labels (films), synthetic paper may not be supported.
- Label wound-in is recommended to use.
- 75mm label core adapter can be supplied as an option.
- Use only die-cut labels.
- A cotton-swab moistened with ALCOHOL, is recommended to wipe adhesive from Mech-Sensor.
